ENTIRE ORDER SHIPS FREE WITH PURCHASE: Hogue Sig Sauer P239 rubber wrap around with finger grooves grips. These grips can be used on both the P239 DA/SA and the P239 DAK.
* GRIP SCREWS ARE NOT INCLUDED.*
Fits both DA/SA models with decocker lever, AND DAK models without decocker lever and hammer spur.
- Fits 9mm, 357SIG or .40 cal pistols
Install decocker side (left) first. It is necessary to maneuver the left panel
into the decocker area while slightly depressing the lever. Then install the
Grip screws should be torqued to 13-15 inch lbs. Blue loctite is suggested on the threads. A quality correct fitting 3/16 hex / Allen or slot driver is a must!
Note if used on a P239 DAK there will be the groove and gap where the decocker would normally be.