Sig Sauer P220 DA/SA Goncalo American Model Checkered 20211


ENTIRE ORDER SHIPS FREE WITH PURCHASE: Hogue Sig Sauer P220 DA/SA Goncalo American Model Checkered 20211.



-SigArms revised the P220 pistol design (approx. 1998) with a new style mainspring system, and a new style trigger bar spring. Current grip (Rev. 10/98)has been revised to fit new and old systems. 
The plastic shim included with the grip must be in place for guns with serial #219166 or below. The shim has the this # engraved into it. This is how to identify the shim.
Serial #s below 219166 place the small plastic shim inside the right grip panel. 
Pistol receivers on serial #s 219166 and above are thicker on right side above mag button. Make sure the shim is removed for these newer pistols. 
-New style has rounded hammer 
-Old style hammer comes more to point

-Standard 220 grip does not fit 220 SAO model with rear 1911 style safety
-We do not offer a grip that will fit the 220 X6. 
-Will fit SAS model, this gun has no decocker lever, grip panel will have slot for decocker.
-P220 R model simply refers to frame having an accessory "Rail", grips are the same.
-DAK compatibility assured by "Rev B" engraved inside both grip panels.

-Wood grips are drilled to Not use stock lock washers. However if screws hit magizine lock washers can be used.
-Screw holes on rubber grips are drilled to use standard Lock Washers. Washers can be removed if more thread attachment is desired. In some cases, screw tips can touch magazine without washers. Use washers if this is the case. 
-Blue Loc-Tite medium strength thread locker is strongly advised.
-See Help Calls for problems regarding screw hole locations
-Grip screws should be torqued to 13-15 inch lbs. A quality correct fitting 3/16 hex / Allen or slot driver is a must!



  • Model: 20211
  • Manufactured by: HOGUE

Be the first to write a review.  Write a Review.