Sig Sauer P239 Rubber Finger Groove Grip OD Green 31001



ENTIRE ORDER SHIPS FREE WITH PURCHASE: Hogue Sig Sauer P239 OD Green rubber wrap around with finger grooves grip. This grip can be used on both the P239 DA/SA and the P239 DAK.



Fits both DA/SA models with decocker lever, AND DAK models without decocker lever and hammer spur.
- Fits 9mm, 357SIG or .40 cal pistols
Install decocker side (left) first. It is necessary to maneuver the left panel 
into the decocker area while slightly depressing the lever. Then install the 
right panel. 

Grip screws should be torqued to 13-15 inch lbs. Blue loctite is suggested on the threads. A quality correct fitting 3/16 hex / Allen or slot driver is a must!
Note if used on a P239 DAK there will be the groove and gap where the decocker would normally be. 




  • Model: 31001
  • Manufactured by: HOGUE

Be the first to write a review.  Write a Review.